Disinfectant HS-2

Do Not Use for Metal Surface Disinfection of Disinfectant HS-2

The simple operation method of disinfectant powder HS-1 for home disinfection

Preparation Method of Disinfectant HS-2

Use a 500ml mineral water bottle or beverage bottle, measure a bottle cap of disinfectant powder HS-1 about 6.5 grams, completely dissolve it in 4L tap water(when a 500ml mineral water bottle is filled 8 times, it is 4L tap water), and obtain a solution with an effective chlorine concentration of 500mg / L. The solution can be directly used for disinfection of the ground and the surface of general objects.

Usage Method of Disinfectant HS-2

For ground disinfection, using the above-mentioned SE-1 solution with a good ratio sprayed once from the outside to the inside, with the spraying amount of 100ml-300ml / m2.

After the indoor disinfection, spray once again from the inside to the outside; general surface disinfection can use wipe or spray. The disinfection time should not be less than 30 minutes.

Precautions of Disinfectant HS-1

• The external disinfectant must not be taken orally. Keep out of reach of children.

  
  

• This product has a corrosive effect on metal and a bleaching effect on the fabric. Use with caution. After the disinfection reaches the specified time, it shall be cleaned in time.

  
  

• Pay attention to personal protection when configuring and using this product. Wear masks, protective gloves, and protective glasses, avoid contact with skin and eyes. In case of inadvertent contact, flush with clear water immediately and seek medical treatment if necessary.

  
  

• lt is not allowed to mix with other chemicals except the chemicals recommended by the manufacturer.

  
  

• During air disinfection, the doors & windows should be closed and carried out without people. After their disinfection, the doors and windows should be opened for ventilation, and people can enter only when there is no peculiar smell.

  
  

• Storage: seal in a cool, ventilated, and dry place under 30c.